UBE Polyethylene B128

About
UBE Polyethylene B128 is a Polyethylene material. It is available in North America for blow molding. Primary attribute of UBE Polyethylene B128: Rigid.&&

Product Description
Supplier	UBE
Generic	PE
Material Status	Commercial: Active
Features	Good Rigidity
Availabilitys	North America

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.928	g/cm³	ASTM D1505
Melt Flow Rate	1.0	g/10min	ASTM D1238

THERMAL	Nominal value	Unit	Test method
Embrittlement temperature	-75.0	℃	ASTM D746
Vicat Softening Temp	102	℃	ASTM D1525

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	58		ASTM D2240
tensile strength
fracture	18.0	MPa	ASTM D638
Tensile strain
fracture	600	%	ASTM D638
Bending modulus
23℃	210	MPa	ASTM D747

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.