UBE Polyethylene J5019

About
UBE Polyethylene J5019 is a Polyethylene material. It is available in North America for injection molding.&&

Product Description
Supplier	UBE
Generic	PE
Material Status	Commercial: Active
Features	Heat Stabilized
Availabilitys	Africa & Middle East ,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.919	g/cm³	ASTM D1505
Melt Flow Rate	50	g/10min	ASTM D1238

THERMAL	Nominal value	Unit	Test method
Embrittlement temperature	-30.0	℃	ASTM D746
Vicat Softening Temp	78.0	℃	ASTM D1525

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	45		ASTM D2240
tensile strength
fracture	8.00	MPa	ASTM D638
Tensile strain
fracture	250	%	ASTM D638
Bending modulus
23℃	110	MPa	ASTM D747

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.