Ultramid® A3K FC Aqua UN

About
Ultramid® A3K FC Aqua UN is optimized for plastic parts, mandatory requiring material approvals for drinking water or direct food contact.&&

Product Description
SupplierBASF
GenericPA66
Material StatusCommercial: Active
FeaturesFood contact compliance
AvailabilitysEurope
Process MethodsInjection Molding

Technical Data

Process Conditions
injectionNominal valueUnitTest method
Drying temperature80°C
Drying time4.0hr
Recommended maximum moisture content0.15%
Hopper temperature80°C
Barrel rear temperature290°C
Barrel middle temperature290°C
Barrel front temperature290°C
Nozzle temperature290°C
Processing (melt) temperature280 to 300°C
Mold temperature60 to 80°C
Screw Speed< 300mm/sec

Notes
1. Typical properties: these are not to be construed as specifications.
2. Test box with central gating, dimensions of base (107*47*1,5) mm, processing conditions: TM = 290°C, TW = 60°C
3. strain <= 0.5%, 23°C
4. 5000 h
5. 20000 h
【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.