Ultramid® A3ZG6

About
An impact-modified, glassfibre reinforced injection moulding grade with good dimensional stability.&&

Product Description
SupplierBASF
GenericPA66
Material StatusCommercial: Active
FeaturesHigh impact resistance,Good Dimensional Stability,Grease resistance
AvailabilitysAsia Pacific,Europe
Process MethodsInjection Molding

Technical Data
handleNominal valueUnitTest method
Melting temperature260°CISO 11357-1/-3
Melting temperature280 – 300
Mold temperature80-90°C
Flame retardant level
1.60 mmHBIEC 60695-11-10
Automotive materials
Thickness>=1mm+FMVSS 302

MECHANICALNominal valueUnitTest method
Tensile modulus8500 / 6000MPaISO 527-1-2
Tensile strain
Fracture stress140/100MPaISO 527-1-2
Fracture strain3.5/6%ISO 527-1/2
Tensile creep modulus
1000h, strain<=0.5%, 23 ℃*/3000MPaISO 899-1
Bending modulus7300/4900MPaISO 178
Bending strength210/150MPaISO 178

THERMALNominal valueUnitTest method
Hot deformation temperature
1.8 MPa240ISO 75-1/2
Maximum operating temperature
Short cycle operation220°C
TD:23~80℃25-35E-6/KISO 11359-1/-2
MD:23~80℃60-70E-6/KISO 11359-1/-2
Thermal conductivity0.35W/(m K)DIN 52612-1
Specific heat capacity1700J/(kg*K)

Electrical performanceNominal valueUnitTest method
1 MHz3.5/5.5IEC 60250
Dissipation coefficient
1MHz140/1600E-4IEC 60250
Volume resistivity1E+15ohms·cmIEC 60093
Surface resistivity1E+10ohmsIEC 60093
Compared to the leakage tracing index
Solution A550IEC 60112

IMPACTNominal valueUnitTest method
Charpy Notched Impact Strength
23℃19/26kJ/m²ISO 179/1eU
23℃90/95kJ/m²ISO 179/1eU
Impact strength of cantilever beam notch
23℃17/20kJ/m²ISO 180-A

PHYSICALNominal valueUnitTest method
Melt Volume Rate
275℃,5 kg15cm³/10minISO 1133
Shrinkage rate0.55%
Density1.330g/cm³ISO 1183
Viscosity value
160g/cm³SO 307, 1157, 1628
Water absorption rate
Equilibrium, 23 ℃, 50% RH1.30 – 1.70%ISO 62
23℃4.7-5.3%ISO 62

Notes
1. Typical properties: these are not to be construed as specifications.
2. Test box with central gating, dimensions of base (107*47*1,5) mm, processing conditions: TM = 290°C, TW = 80°C
3. strain <= 0.5%, 23°C
【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.