| About |
|---|
| Thermoplastic compound based on EPDM with PP (TPE-V) dynamically vulcanized, suitable for high performance applications where outdoor exposure or resistance to high temperature (135°C) are important requirements.&& |
| Product Description | |
|---|---|
| Generic | PP+EPDM |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,High Heat Resistance |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.990 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 2.0 to 3.0 | % | ASTM D955 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 37 to 43 | ASTM D2240 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | ASTM D412 | ||
| fracture | 4.50 | MPa | ASTM D412 |
| 100% strain | 1.20 | MPa | ASTM D412 |
| 300% strain | 2.30 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | 550 | % | ASTM D412 |
| tear strength | 20.0 | kN/m | ASTM D624 |
| Compression deformation | |||
| 70℃，22 hr | 31 | % | ASTM D395B |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 80 | °C | |
| Drying time | 2.0 | hr | |
| Processing (melt) temperature | 180 to 200 | °C | |
| Mold temperature | 25 to 50 | °C | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |