UNISOFT ADHESION™ AD-90A-NT-1-01

About
TPE Compound based on Styrene-Ethylene/Butylene-Styrene Block Copolymer Special bonding grade to PC/ABS, PC/PBT, PC, ABS, PBT, PET and PET-G; Unisoft Adhesion™ AD-90A-NT-1-01 is a general adhesion grade intended for use in injection molding and extrusion processes. All ingredients used for this compound are in compliance with certain FDA regulations.&&

Product Description
Generic	SEBS
Material Status	Commercial: Active
Features	Block Copolymer,Good bond,Agglomerability
Availabilitys	North America
Process Methods	Extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.17	g/cm³	ASTM D792
Shrinkage rate
MD	0.50 to 1.1	%	ASTM D955

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s A	90		ASTM D2240

elastic body	Nominal value	Unit	Test method
tensile strength
yield	11.0	MPa	ASTM D412
Tensile strain
fracture	550	%	ASTM D412

Process Conditions
injection	Nominal value	Unit	Test method
Drying temperature	66	°C
Drying time	2.0 to 4.0	hr
Barrel rear temperature	199 to 210	°C
Barrel front temperature	218 to 229	°C
Nozzle temperature	235 to 246	°C
Mold temperature	41 to 66	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.