Valtec HS013 - SOLIAO

About
Compared to a pellet-form polypropylene, Valtec could present advantages in terms of improved productivity, better processing and lower energy consumption. Valtec HS013 is a homopolymer particularly suitable for the extrusion of fibers, multifilament, decorative ribbons and general purpose injection molding. Valtec HS013 has a UL yellow card flammability rating of 94 HB at a minimum thickness of 1.5 mm. The base resin in this product meets the requirements of the FDA contained in the Code of Federal Regulations in 21 CFR 177.1520. Features: Outstanding processability High rigidity Wide processing window High resistance to chemicals and solvents Typical Applications: Fibers Multifilament Ribbons Injection Housewares&&

About

Compared to a pellet-form polypropylene, Valtec could present advantages in terms of improved productivity, better processing and lower energy consumption. Valtec HS013 is a homopolymer particularly suitable for the extrusion of fibers, multifilament, decorative ribbons and general purpose injection molding. Valtec HS013 has a UL yellow card flammability rating of 94 HB at a minimum thickness of 1.5 mm. The base resin in this product meets the requirements of the FDA contained in the Code of Federal Regulations in 21 CFR 177.1520. Features: Outstanding processability High rigidity Wide processing window High resistance to chemicals and solvents Typical Applications: Fibers Multifilament Ribbons Injection Housewares&&

Product Description
Generic	PP homopolymerization
Material Status	Commercial: Active
Features	Good Rigidity,Excellent Processability,Food contact compliance,Solvent resistance,Homopolymer
Availabilitys	North America,Latin America
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.900	g/cm³	ASTM D792
Melt Flow Rate
230℃，2.16kg	11	g/10min	ASTM D1238

MECHANICAL	Nominal value	Unit	Test method
tensile strength
yield	35.0	MPa	ASTM D638
Tensile strain
yield	10	%	ASTM D638
Bending modulus	1500	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	32	J/m	ASTM D256-A

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	100	℃	ASTM D648

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.