| About |
|---|
| The Versaflex™ HC 1100-40 Translucent EU is an overmolding TPE with very good adhesion to PC or ABS-based plastics. Good Surface Aesthetics Rubbery Feel Soft Touch Very Good Bond to PC, ABS, PC/ABS may be appropriate where FDA compliance is required&& |
| Product Description | |
|---|---|
| Supplier | Polyone |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good surface appearance,Good coloring |
| Availabilitys | Africa & Middle East ,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Shore hardness | |||
| Shore A, 3 seconds | 44 | DIN 53505 | |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Fracture, 23 ℃, 2 mm | 5.40 | MPa | ISO 37 |
| 100% strain, 23 ℃, 2 mm | 1.00 | MPa | |
| 300% strain, 23 ℃, 2 mm | 2.00 | MPa | |
| Tensile strain | |||
| Fracture, 23 ℃, 2 mm | 730 | % | ISO 37 |
| tear strength | 18.0 | kN/m | ISO 34 |
| Compression deformation | |||
| 23℃，22 hr | 22 | % | ASTM D395B |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 0.917 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 190℃，5.0kg | 75 | g/10min | ISO 1133 |
| Shrinkage rate | |||
| MD | 2.0 to 2.6 | % | ISO 294-4 |
| Apparent viscosity of melt | |||
| 200℃，11200 sec^-1 | 10.5 | Pa·s | Internal Method |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Proposed maximum recycled material ratio | 20 | % | |
| Barrel rear temperature | 165 to 190 | °C | |
| Barrel middle temperature | 180 to 200 | °C | |
| Barrel front temperature | 185 to 205 | °C | |
| Nozzle temperature | 195 to 215 | °C | |
| Processing (melt) temperature | 185 to 210 | °C | |
| Mold temperature | 20 to 40 | °C | |
| Back pressure | 0.00 to 0.862 | MPa | |
| Screw speed | 75 to 125 | rpm | |
| Notes |
|---|
| 1. Product rating may be influenced by end product design and/or conditions of use. Please contact GLS Thermoplastic Elastomers for information addressing FDA (21 CFR 177.1210) compliance. |
| 2. Typical properties: these are not to be construed as specifications. |
| 3. 7.9 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |