| About |
|---|
| Versaflex OM 9140 Translucent is designed for overmolding onto a wide variety of substrates including PC, ABS, M-ABS, SAN, M-MBS, ASA, COPE, HIPS and PPE/PS blends and may be appropriate where FDA compliance is required. New Product. Commercial specifications have not been established. Bonds to a Variety Of Substrates Rubbery Feel Good surface Aesthetics Soft Touch Short cycle time Good UV resistance&& |
| Product Description | |
|---|---|
| Supplier | Polyone |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Excellent Processability,Good surface appearance |
| Availabilitys | Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Shore hardness | |||
| Shore A, 3 seconds | 40 | ISO 868 | |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Fracture, 2 mm | 6.50 | MPa | ISO 37 |
| 100% strain, 2 mm | 1.25 | MPa | |
| 300% strain, 2 mm | 2.70 | MPa | |
| Tensile strain | |||
| Fracture, 2 mm | 930 | % | ISO 37 |
| Compression deformation | |||
| 23℃，72 hr | 35 | % | ISO 815 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 0.898 | g/cm³ | ISO 1183 |
| Apparent viscosity of melt | |||
| 200℃，11200 sec^-1 | 9.20 | Pa·s | Internal Method |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Proposed maximum recycled material ratio | 20 | % | |
| Barrel rear temperature | 180 to 190 | °C | |
| Barrel middle temperature | 190 to 200 | °C | |
| Barrel front temperature | 200 to 220 | °C | |
| Nozzle temperature | 200 to 230 | °C | |
| Mold temperature | 20 to 40 | °C | |
| Back pressure | 0.172 to 0.345 | MPa | |
| Screw speed | 75 to 125 | rpm | |
| Notes |
|---|
| 1. Product rating may be influenced by end product design and/or conditions of use. Please contact GLS Thermoplastic Elastomers for information addressing FDA compliance. |
| 2. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |