| About |
|---|
| Glass-fiber reinforced polyphthalamide compound for injection molding VESTAMID HTplus M1036 is a glass-fiber reinforced (60%), heat-stabilized polyphthalamide compound (PPA) for injection molding. This compound is especially suitable for manufacturing parts subjected to high temperature.&& |
| Product Description | |
|---|---|
| Supplier | Evonik |
| Generic | PPA |
| Material Status | Commercial: Active |
| Features | High Heat Resistance,Heat Stabilized |
| Availabilitys | North America,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.77 | g/cm³ | ISO 1183 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 23000 | MPa | ISO 527-2 |
| tensile strength | |||
| fracture | 280 | MPa | ISO 527-2 |
| Tensile strain | |||
| fracture | 1.5 | % | ISO 527-2 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | ISO 179/1eA | ||
| -40 ℃, completely fractured | 19 | kJ/m² | ISO 179/1eA |
| 23 ℃, completely fractured | 17 | kJ/m² | ISO 179/1eA |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | |||
| — | 319 | ℃ | ISO 306/A |
| — | 290 | ℃ | ISO 306/B |
| Melting temperature | 300 to 315 | ℃ | ISO 11357-3 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 120 | °C | |
| Drying time | 4.0 | hr | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2nd heating |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |