| About |
|---|
| VESTOLIT G M117 (120 Series) is a Polyvinyl Chloride Homopolymer (PVC Homopolymer) material. It is available in Africa & Middle East, Asia Pacific, Europe, Latin America, or North America for coating, dip coating, rotational molding, or slush molding. Primary attribute of VESTOLIT G M117 (120 Series): High Strength.&& |
| Product Description | |
|---|---|
| Generic | PVC homopolymer |
| Material Status | Commercial: Active |
| Features | Good Rigidity |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Optimal stretching | 20.1 | MPa | ASTM D638 |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| gloss | Internal Method | ||
| 60 degree fused 3 mins @ 390F | 92 | % | Internal Method |
| 60 degree fused 5 mins @ 350F | 61 | % | Internal Method |
| Transmittance | 94 | % | Internal Method |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| North fineness | 3.25 | Hegman | Internal Method |
| Residual Vinyl Chloride Monomer | < 9 | ppm | Internal Method |
| Methanol extractable | 2.2 | % | Internal Method |
| polymerization process | Microsuspension | ||
| Gel temperature | 65 | ℃ | Internal Method |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 1.40 | g/cm³ | ASTM D792 |
| Apparent density | 0.46 | g/cm³ | |
| K-Value | 74.0 | Internal Method | |
| Intrinsic viscosity | 1.2 | Internal Method | |
| humidity | |||
| Karl Fisher | 0.040 | % | Internal Method |
| Relative viscosity | |||
| Cyclohexanone 1% | 2.65 | ||
| Brookfield viscosity | Internal Method | ||
| Initial viscosity @ 2 rpm | 5.98 | Pa·s | Internal Method |
| Initial viscosity @ 20 rpm | 4.80 | Pa·s | Internal Method |
| One day viscosity @ 2 rpm | 6.40 | Pa·s | Internal Method |
| One day viscosity @ 20 rpm | 6.45 | Pa·s | Internal Method |
| Cut off the outflow | 48.00 | g/10 min | Internal Method |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 0.5g/100ml |
| 3. ASTM D 1243 60 A |
| 4. STP 683 |
| 5. ATLC 66 |
| 6. ALTC 65 |
| 7. ALTC 22 |
| 8. STP 1010 |
| 9. ATLC 29 |
| 10. STP 894 |
| 11. STP 390 |
| 12. STP 1005 |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |