| About |
|---|
| Product Description | |
|---|---|
| Generic | 氨基树脂 |
| Material Status | Commercial: Active |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| bending strength | ≥80 | Mpa | GB13454-92 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | ≥115 | ℃ | GB13454-92 |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Water absorption rate | |||
| cold water | ≤50 | mg | GB13454-92 |
| Shrinkage rate | 0.5~1.00 | % | GB13454-92 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Surface resistivity | ≥1E+10 | ohms | GB13454-92 |
| Dielectric strength | |||
| 90℃ | ≥7E+5 | kV/mm | GB13454-92 |
| tanδ | ≤0.1 | 1MHz | GB13454-92 |
| Compared to the resistance to leakage and marking index | 600 | GB13454-92 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | ≥1.7 | kJ/m² | GB13454-92 |
| Process Conditions | |||
|---|---|---|---|
| injection molding | Nominal value | Unit | Test method |
| Barrel temperature | 70-75 | ℃ | |
| Mold temperature | 135-155 | ℃ | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |