| About |
|---|
| This TPO compound has been tailored specifically to meet the requirements of each of the major automobile producers. Features include good scuff, nick and wear resistance and also very good ductility and practical toughness. This compound also features medium flow and an excellent balance of impact strength and rigidity. Typical applications include air dams, facias, cladding, and other various automotive applications.&& |
| Product Description | |
|---|---|
| Generic | Polyolefin Elastomer |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good flexibility,High impact resistance,Ductility,Moderate liquidity,Good wear resistance,High scratch resistance |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.898 | g/cm³ | ASTM D792 |
| Melt Flow Rate | 9.0 | g/10min | ASTM D1238 |
| Shrinkage rate | |||
| MD | 1.2 | % | ASTM D955 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 20.7 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 500 | % | ASTM D638 |
| Bending modulus | |||
| tangent | 938 | MPa | ASTM D790 |
| bending strength | 26.9 | MPa | ASTM D790 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tear strength | 114 | kN/m | ASTM D624 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 21℃ | 560 | J/m | ASTM D256 |
| Dart impact equipped with measuring instruments | |||
| -30℃ | 27.1 | J | ASTM D3763 |
| Drop hammer impact | |||
| -30℃ | 27.1 | J | ASTM D3029 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Proposed maximum recycled material ratio | 20 | % | |
| Processing (melt) temperature | 207 to 221 | °C | |
| Mold temperature | 10 to 49 | °C | |
| Injection speed | Slow-Moderate | ||
| Clamping force | 2.8 to 5.5 | kN/cm² | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 3. 0.50 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |