About |
---|
WR® 525 is a thermoplastics composite consisting of carbon fiber in a PEEK™ matrix. WR provides excellent chemical resistance, non-galling and nonseizing properties, impact resistance and thermal shock and hydrolysis resistance. WR 525 allows the pump user to increase pump efficiency by running tighter wear rings clearances while decreasing potential pump damage when pumos are cavitated or experience down-line bearing failures.&& |
Product Description | |
---|---|
Generic | PEEK |
Material Status | Commercial: Active |
Features | High impact resistance,Low coefficient of friction,Good thermal shock resistance,Solvent resistance |
Availabilitys | North America |
Technical Data | |||
---|---|---|---|
PHYSICAL | Nominal value | Unit | Test method |
Density | 1.63 | g/cm³ | ASTM D792 |
THERMAL | Nominal value | Unit | Test method |
---|---|---|---|
Maximum operating temperature | 525 |
MECHANICAL | Nominal value | Unit | Test method |
---|---|---|---|
Shore hardness | |||
Shaw’s D | 98 | ASTM D2240 | |
Tensile modulus | ASTM D3039 | ||
— | 138000 | MPa | ASTM D3039 |
— | 10200 | MPa | ASTM D3039 |
tensile strength | ASTM D3039 | ||
fracture | 207 | MPa | ASTM D3039 |
fracture | 86.2 | MPa | ASTM D3039 |
Compression modulus | 124000 | MPa | ASTM D695 |
compressive strength | 1360 | MPa | ASTM D695 |
Notes |
---|
1. Typical properties: these are not to be construed as specifications. |
2. Perpendicular to fiber |
3. Parallel to fiber |
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |