YUPLENE® B391M

About
Y UPLENE B391M is a propylene impact copolymer designed for injection molding applications. YUPLENE B391M has high stiffness, excellent dimensional stability, good impact strength and very high flowability. This is not a chemical cracked grade so it is free from surface gas mark. YUPLENE B391M is especially suitable for various electrical appliances, large products and thin wall products. YUPLENE B391M complies with FDA regulation 21 CFR177.1520. Application: Injection Molding / automobile applications, industrial parts for electronic, large container&&

About

Y UPLENE B391M is a propylene impact copolymer designed for injection molding applications. YUPLENE B391M has high stiffness, excellent dimensional stability, good impact strength and very high flowability. This is not a chemical cracked grade so it is free from surface gas mark. YUPLENE B391M is especially suitable for various electrical appliances, large products and thin wall products. YUPLENE B391M complies with FDA regulation 21 CFR177.1520. Application: Injection Molding / automobile applications, industrial parts for electronic, large container&&

Product Description
Supplier	SKC
Generic	PP homopolymerization
Material Status	Commercial: Active
Availabilitys	North America,Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Melt Flow Rate
230℃，2.16kg	40	g/10min	ASTM D1238
Spiral flow length	> 80.0	cm	Internal Method

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch			ASTM D256
-20℃	49	J/m	ASTM D256
23℃	74	J/m	ASTM D256

Aging performance	Nominal value	Unit	Test method
Oven Aging
In the air, 150 ℃	15.0	day	ASTM D3012

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp	150	℃	ASTM D1525
Hot deformation temperature	110	℃	ASTM D648

Supplementary information	Nominal value	Unit	Test method
DuPont Impact Strength	> 1.96	J	ASTM D2794

MECHANICAL	Nominal value	Unit	Test method
Rockwell hardness
R-level	90		ASTM D785
tensile strength
yield	25.5	MPa	ASTM D638
Tensile strain
fracture	< 500	%	ASTM D638
Bending modulus	1270	MPa	ASTM D790

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.