| About |
|---|
| Yuyao PPO SE1X701 is a Polyphenylene Ether + PS (PPE+PS) product. It can be processed by injection molding and is available in Asia Pacific. Typical application: Electrical/Electronic Applications. Characteristics include: Flame Rated Chemical Resistant Flame Retardant Good Dimensional Stability Heat Resistant&& |
| Product Description | |
|---|---|
| Supplier | Tenglong |
| Generic | PPO(PPE)+PS |
| Material Status | Commercial: Negative |
| Features | Good Rigidity,Good Dimensional Stability,Good Electrical Properties,Low contractility,Flame Characteristics,High Heat Resistance,Solvent resistance,V-0 |
| Availabilitys | Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.09 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 0.50 to 0.80 | % | ASTM D955 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 60.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 4.0 | % | ASTM D638 |
| Bending modulus | 3200 | MPa | ASTM D790 |
| bending strength | 90.0 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 7.00 | kJ/m² | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 120 | ℃ | ASTM D648 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 2.3E+3 | ohms·cm | ASTM D257 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | UL 94 | ||
| 1.60 mm | V-0 | UL 94 | |
| 3.20 mm | V-0 | UL 94 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 100 to 115 | °C | |
| Drying time | 4.0 to 5.0 | hr | |
| Processing (melt) temperature | 250 to 280 | °C | |
| Mold temperature | 60 to 80 | °C | |
| Injection pressure | 70.0 to 100 | MPa | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |